Axle Sensor Kit - Mopar (sensor for differential)

sensor kit for the differential lock sensor Super Lube® Silicone Dielectric Grease is required due to known resistance of the temperatures and fluid properties encountered inside of the axles.
Apply Super Lube® Silicone Dielectric Grease into the axle locker sensor wire harness connector cavity.
Connect the axle locker sensor marked #1 to the harness connector.
Do not bend or damage the magnet plate.
Using a trim stick, carefully move magnet plate towards the ring gear while installing the axle locker sensor into position.
Install the axle locker sensor mounting screw and tighten securely.
Lower the vehicle.
Turn the ignition to the ON position and check for Service Axle Locker message:
If the Service Axle Locker message is NOT present, turn the ignition OFF and continue with Installation.
If the Service Axle Locker message is present, turn the ignition OFF and replace the axle locker sensor as necessary in consecutive order from #2 - #5. Retest for the Service Axle Locker message after each sensor is installed until message is NOT present when the ignition is turned ON and then continue with Installation.